Guide · Roofing

Chimney flashing and chimney repair as an add-on line for roofers: which jobs are yours, how to find the leak, and ads apart from roof repair

  • By Kausar Ahmed, Founder, Digital Hark
  • Updated
  • 9 min read
Roofer in a harness fitting step flashing beside a brick chimney on a shingle roof

The short answer

When a leak call ends at the chimney, the flashing where the chimney meets the roof is roof work; the brick, crown, liner and cleaning usually belong to a mason or chimney sweep. Find where the water gets in before you quote, give chimney flashing its own ad group and page, refer the rest, and judge it by signed jobs.

Key takeaways

  • Flashing, counterflashing and the cricket are roof work; brick, liner and cleaning are not.
  • Find the leak source before you quote: new flashing does not fix a leaking crown.
  • Texas has no state license for roofers; check your city's code and permits.
  • Give chimney flashing its own ad group, page and mason / sweep negatives.

Why do so many roof leak calls end at the chimney?

A chimney is a large opening through the roof, sealed with metal where it meets the shingles. This Old House: "Flashing seals the area where the chimney meets the roof, protecting your home from leaks." When that seal fails, the homeowner sees a ceiling stain beside the chimney and calls a roofer. For flashing, Bob Vila says "a roofer is the best person to call, and quickly."

Roofer checking a water stain on the ceiling beside a brick chimney inside a home.
When the flashing fails, the homeowner sees a ceiling stain beside the chimney.

Calls can pile up after hard weather. In a 2015 CBS Texas story, one Dallas roofer said chimney leak calls went from "five to ten calls a week" to "150 to 200 a day" after a long drought and then record rains. That is one roofer's account from 2015, not a forecast.

Like attic ventilation and insulation, chimney flashing is work your crew already finds on roof calls. The difference: part of every chimney belongs to other trades.

Flashing, crown, cap or brick: which part is the roofer's job?

Roof side (yours)

  • Step flashing, woven in with the shingles along the sides of the chimney.
  • Counterflashing, set into the brick and lapped over the step flashing.
  • The cricket (saddle), the small peaked section on the uphill side of a wide chimney that sends water around it.

Not roof side (refer, unless your company really does it)

  • Brick and mortar repair, tuckpointing and rebuilds: a mason.
  • The crown (the top slab) and the cap (the cover over the flue): a mason or chimney sweep.
  • Liner, cleaning and inside inspection: a chimney sweep. Bob Vila says chimneys should be "cleaned and inspected at least once a year".

Which part is whose

Flashing, counterflashing and the cricket are roof work; brick, liner and cleaning are not.

The Chimney Safety Institute of America runs a private credential: "To become a CSIA Certified Sweep®, you must complete a CCS® review and pass the CCS® exam." It is not a state license; never claim it unless someone on your team holds it.

In short

List only the chimney work your crew really does, on the page, in the ads and on the call.

How do you find where a chimney leak starts before you quote?

A roofing company's guide says: "Before the leak can be successfully repaired, the source needs to be identified." Before you quote:

  1. Ask where and when the water shows (questions below).
  2. Check the attic beside the chimney. Bob Vila: "If the roof's flashing is to blame, the water will be leaking into the attic as well as down the chimney."
  3. Look at each side from the roof. This Old House lists signs such as "Rusty flashing or chimney cap" and "White staining (efflorescence) on the exterior brickwork".
  4. Water-test from the bottom up. The same roofing guide: "soak small sections of your chimney, one at a time. Start this process near the chimney's base".
  5. Write down which part leaks and which part is not yours. If the brick or crown lets water in, new flashing alone is not the fix.

Before you quote

If the brick or crown lets water in, new flashing alone is not the fix.

Photograph each side of the chimney for the inspection report; our guide to taking and captioning roof photos shows how.

When should a roofer send the job to a mason or chimney sweep?

When the cause is not the flashing: cracked or missing mortar, a cracked crown, a damaged liner, water in the firebox with sound flashing, or a homeowner asking for cleaning.

Close-up of a cracked concrete crown and a metal cap on top of an old brick chimney.
New flashing does not fix a leaking crown; refer it to a mason or chimney sweep.
  • Keep a short list of one or two masons and a chimney sweep you trust.
  • Say it on the call and in the report: "The flashing is ours; the crown needs a mason. Here are two names." The homeowner chooses.
  • If both trades are needed, agree the order with the mason first.

Marketing pages for chimney and masonry companies name roofers as referral partners, so referrals can run both ways.

What do the building code and Texas rules say about chimney flashing?

The model code. The International Residential Code 2021, section R903.2.1, says: "Flashings shall be installed at wall and roof intersections, wherever there is a change in roof slope or direction and around roof openings." Section R903.2.2 adds: "A cricket or saddle shall be installed on the ridge side of any chimney or penetration more than 30 inches (762 mm) wide as measured perpendicular to the slope." And: "Cricket or saddle coverings shall be sheet metal or of the same material as the roof covering."

Cities adopt a code edition and may amend it: check your city's edition and whether the work needs a permit.

Texas licensing. A 2025 Texas House bill analysis says: "Texas does not currently require a state-issued license for reroofing contractors." That bill, HB 3344, would have created one; it stopped in the House (last action May 8, 2025). We found no state license for roofing, masonry or chimney sweeping on the Texas Department of Licensing and Regulation's list.

So do not write "state-licensed" in a Texas roofing ad; our guide to license numbers in contractor ads has the same Texas line. Cities may still ask for registration. This is general information, not legal advice.

Which chimney searches are roof work, and which belong to masons and chimney sweeps?

Google Keyword Planner (US, November 2026) shows about 6,600 monthly searches for "chimney flashing" and 3,600 for "chimney flashing repair", fewer than a year earlier, with medium to high competition.

Own ad group, apart from roof repair. Keywords might look like: chimney flashing repair, chimney leak repair, leak around chimney, chimney flashing [your town]. For set-up, see the keywords section of our Google Ads guide for roofers.

Negatives for work you don't do (our view; adjust to your crew):

Leave toWords to block
Chimney sweepschimney sweep, chimney cleaning, chimney liner, chimney inspection (if you do no inside inspection), fireplace, gas fireplace
Masonstuckpointing, brick repair, chimney rebuild, chimney crown (if you don't do crowns), chimney cap (if you don't do caps)
DIY and product buyerskit, how to, sealant, caulk

Our negative keywords guide explains match types, including "how to" as phrase match.

A chimney leak landing page, not the home page: the parts you fix, how you find the leak, and where brick and crown work goes.

Business Profile: list chimney flashing repair under Services only if your crew does it, and add categories only for real lines of work.

Ad wording: "Chimney flashing and chimney leak repair, from the roof side." Don't promise the leak will never come back or claim brick or liner work. If an ad names a warranty, follow the warranty ad rules.

What do you ask when a chimney leak call comes in?

Use the eight first-call questions from our guide to qualifying roofing leads, and add these:

  1. Where does the water show: beside the chimney, in the attic, or inside the fireplace?
  2. When: every rain, only in wind-driven rain, or after ice?
  3. Brick chimney, or one boxed in with siding?
  4. When was it last swept or inspected?
  5. Any recent roof or chimney work?
  6. Can you send photos of the stain and the chimney? (Texts only with consent; our speed-to-lead guide covers texting rules.)

If the answers point to the firebox or the brick, say you may send part of the job to a mason or sweep.

How do you know chimney work pays?

Count signed flashing jobs, not calls.

  1. Add "chimney" as a CRM lead source, with its own call tag on the ads and the page.
  2. Count calls, inspections, quotes, signed flashing jobs, referrals to masons or sweeps, and roof estimates from those calls.
  3. Divide chimney ad spend by signed flashing jobs, as in our cost per signed job guide.
One season of chimney adsCount
Chimney leak calls24
Inspections16
Flashing quotes sent11
Signed flashing jobs6
Sent to a mason or chimney sweep5
Roof estimates from those calls2

From chimney calls to signed jobs

Count signed flashing jobs, not calls.

Worked numbers in this guide show the method; they are not real client results. In this table, 24 chimney calls gave 16 inspections and 6 signed flashing jobs.

Where Digital Hark fits

Digital Hark builds the marketing side for Texas roofing companies: the chimney ad group and negatives, a chimney leak landing page, a "chimney" call tag, CRM steps and reports by signed job. Your crew inspects, quotes and repairs. We don't inspect or repair roofs or chimneys, and we give no building-code, licensing or legal advice. We never call or text your leads, book jobs or sell for you. More on our page for roofing companies.

Common questions

Is chimney flashing a roofer's job or a mason's?

The flashing where the chimney meets the roof is roof work: step flashing, counterflashing and the cricket. Brick and mortar go to a mason; liner and cleaning to a chimney sweep.

Does Texas require a license to repair chimney flashing?

Texas has no state license for roofers; a 2025 bill to create one stopped in the House. Cities may still ask for registration or permits. This is general information, not legal advice.

When does a chimney need a cricket?

The International Residential Code 2021 (R903.2.2) calls for a cricket or saddle on the ridge side of any chimney more than 30 inches wide, measured across the slope. Check your city's code edition.

Why does a chimney still leak after new flashing?

Water can also get in through the brick, mortar, crown or cap. Find the source before you quote.

Which words should a roofer block in chimney ads?

Words for work you don't do, such as chimney sweep, chimney cleaning, chimney liner, tuckpointing and chimney rebuild, plus DIY words like kit and caulk.

Who should clean or reline a chimney?

A chimney sweep, unless your crew is trained for it. CSIA certification is a private sweep credential, not a state license; claim it only if someone on your team holds it.

Kausar Ahmed, Founder, Digital Hark. Digital Hark runs ads, landing pages, tracking and follow-up systems for home-service contractors. We do not inspect or repair roofs or chimneys, and we give no building-code, licensing or legal advice. This is general information. We are not affiliated with the CSIA or any company quoted here. About Digital Hark

Find out where your leads are being lost

Book a free Growth Diagnosis. We review your ads, website and follow-up, and send you a short written summary of the top leaks and what to fix first.

Check my chimney leads

We reply within 24 hours

Free Growth Diagnosis